Craftsman 315.111920 Bedienungshandbuch

Owner's ManualCRAFTSMAN°3/8 in. Two Speed / ReversibleCORDLESS DRILLModel No.315.111920-_, CAUTION: Readandfollow all Safety Rules andOperating I

INSTALLING BITSSee Figure 6.• Lock the switch trigger by placing the direction ofrotation selector in center position. See Figure 2.• Open or close ch

WARNING: Always wear safety goggles orsafety glasses with side shields when operatingtools. Failure to do so could result in objectsbeing thrown into

CHUCK REMOVALSee Figures 10, 11, and 12.The chuck must be removed in order to use someaccessories. To remove:• Lock the switch trigger by placing the

,_ WARNING: When servicing, use only identicalCraftsman replacement parts. Use of any otherpart may create a hazard or cause productdamage.Avoid using

14

CRAFTSMAN 3/8 INCH CORDLESS DRILL - MODEL NO. 315.111920I1The model number will be found on a plate attached to the motor housing. Always mentionthe m

Fortherepairorreplacementpartsyouneeddelivereddirectlyto yourhomeCall7 am- 7 pro,7 daysa week1-800-366-PART(1-800-366-7278)ForrepairserviceCall24 hour

• Warranty ...

The purpose of safety symbols Is to attract your attention to possible dangers. The safety symbols, andthe explanations with them, deserve your carefu

RULES FOR SAFE OPERATION (Continued)NEVER USE IN AN EXPLOSIVE ATMO-SPHERE. Normal sparking of the motor couldignite flammable liquids, gases, or fumes

RULES FOR SAFE OPERATION (Continued)• An extension cord should not be used unless •absolutely necessary. Use of improperextension cord could result in

The following recommended accessories are currently available at Sears Retail Stores.• 6-Pc. Extra Length Magnite Power Bit Set • High Speed Bits (For

_lb WARNING: Always wear safety goggles orsafety glasses with side shields when operatingtools. Failure to do so could result in objectsbeing thrown i

SWITCHSee Figure 2.To turn your drill ON, depress the switch trigger. Toturn it OFF, release the switch trigger.SELECTORBA'n'ERYCENTERPosrno

SWITCH LOCKSee Figure 4.The switch trigger can be locked in the OFF position.This feature can be used to prevent the possibilityofaccidental starting