Craftsman PGT9000 Bedienungsanleitung PDF herunterladen (Seite 27)

100

SERVICE AND MAINTENANCE

DECK REAR ROLLER ADJUSTMENT

The rear rollers on the mower deck are

not

designed to carry the

weight of the deck. The rear rollers should be adjusted to approxi

mately 1/4” to 1/2” above the ground when the deck Is moved to the

desired cutting height.

Place the tractor on a smooth, flat surface, move the deck to the

desired cutting height, and check the height of the rear rollers. If

contacting the ground, or above 1/2” from the ground, adjust the rear

rollers as follows:

The deck roller assembly Index bracket has five adjustment positions

holes.

1. While supporting the roller assembly, remove click pin and

withdraw the clevis pin from both the left and right roller Index

brackets. See Figure 26.

Index Bracket

Figure 26

2. Position the roller assembly so that the rollers are approximately

1/4” to 1/2” above the flat surface below.

3. Align the nearest Index bracket holes with the holes In the deck

mounting brackets. Insert the clevis pins through the deck

brackets and the Index brackets and secure with the click pins.

See Figure 26.

NOTE:

The clevis pins should be In the corresponding holes of both

the left and right roller index brackets.

ENGINE MAINTENANCE

Checking the Engine Oil

Only use high quality detergent oil rated with API service classification

SF, SG, SFI, or SJ. Select the oil's SAE viscosity grade according to

the expected operating temperature. Follow the chart below.

older'

■32T -Warmer

5y\/20

SAE30

Oil Viscosity Chart

Although multi-viscosity oils (5W20,10W30, etc.) improve starting

in cold weather, they will result in increased oil consumption when

used above 32°F. Check your engine oil level more frequently to avoid

possible engine damage from running low on oil.

To check the engine oil, proceed as follows:

1. Ensure that the tractor is on a level surface.

Clean the oil fill area of any debris.

Remove the dipstick and wipe with a clean cloth.

Insert and tighten dipstick.

Remove the dipstick and check the oil level. It should be at the

Full mark on the dipstick. See Figure 27.

Figure 27

If low, add oil slowly into the engine oil fill. Do not overfill. After

adding oil, wait one minute and then recheck the oil level.

A CAUTION

Do not overfill. Cverfilling with oil may cause the engine to not start,

hard starting, or engine smoking. If over the FULL mark on the

dipstick, drain oil to reduce oil level to FULL mark on dipstick.

7. Replace and tighten dipstick.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 99 100

Kommentare zu diesen Handbüchern

Keine Kommentare

Craftsman PGT9000 Bedienungsanleitung Seite 27

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Gartengeräte Craftsman PGT9000