Craftsman CM1600 Bedienungshandbuch PDF herunterladen (Seite 10)

How to Use Spray Tips

You should now be familiar with how to START and STOP your

electric pressure washer. If not, please refer to the previous

section to familiarize yourself with STARTING and STOPPING the

system before continuing.

There are three spray tips supplied with the pressure washer. The

turbo spray tip whirls a powerful pin-point jet of water for intense

cleaning. The white tipped spray tip is for general soap applica-

tions and the orange tipped spray tip is for various high pressure

applications.

Usage Tips

• For most effective cleaning, keep spray tip from 8 to 24 inches

away from cleaning surface.

• If you get spray tip too close, especially using a high pressure

setting, you may damage surface being cleaned.

• Do Not get closer than 6 inches when cleaning tires.

Applying Detergent

WARNING Chemical Burn Hazard.

Chemicals could cause burns resulting in death

or serious injury.

• Always wear indirect vented (chemical splash) safety goggles

marked to comply with ANSI Z87.1 when using chemicals.

• DO NOT substitute safety glasses or dry-condition goggles for

indirect vented safety goggles.

• DO NOT use caustic liquid with electric pressure washer

• Use ONLY pressure washer safe detergents/soaps. Follow all

manufacturers instructions.

To apply detergent, follow these steps:

1. Review use of spray tips in How to Use Spray Tips.

2. Tip unit back and remove detergent tank cap.

3. Fill tank with a detergent mixture designed for power

washers. The solution should be the consistency of water to

prevent clogging in the detergent system.

4. Reinstall detergent tank cap and tip unit back upright.

5. Install black tipped spray tip.

NOTICE Do not ﬁll above bottom of ﬁller tank neck or detergent

will leak out of cap when tipped back upright.

1. Make sure garden hose is connected to water inlet. Check

that high pressure hose is connected to spray gun and

pump. Turn on water.

2. NOTICE You must attach all hoses before you start the pres-

sure washer.

3. Start the pressure washer as instructed in How to Start Your

Electric Pressure Washer.

4. Apply detergent to a dry surface, starting at lower portion

of area to be washed and work upward using long, even,

overlapping strokes.

5. Allow detergent to “soak in” for 3-5 minutes before washing

and rinsing. Reapply as needed to prevent surface from

drying. To prevent streaking, do not allow detergent to dry on

surface.

Electric Pressure Washer Rinsing

1. Remove black tipped spray tip from wand.

2. Install white or yellow tipped spray tip.

3. Keep spray gun a safe distance from area you plan to spray.

WARNING Risk of kick back.

Spray gun could kick back causing you to fall resulting

in death or serious injury.

• Operate the electric pressure washer from a stable surface.

• Be extremely careful if you must use the electric pressure

washer from a ladder, scaffolding, or any other similar location.

• Firmly grasp spray gun with both hands when using power

spray modes to avoid injury when spray gun kicks back.

NOTICE Detergent can only be applied with black spray tip.

• Apply a high pressure spray to a small area and then check

surface for damage. If no damage is found, you can assume

it is okay to continue rinsing.

• Start at top of area to be rinsed, working down with same

overlapping strokes as you used for cleaning.

Other Cleaning Tips

• NEVER leave the electric pressure washer unattended while

it is plugged into an electrical outlet and while water is sup-

plied to the equipment.

• If you have the nozzle too far away from the surface being

washed, the cleaning may not be as effective.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

Craftsman CM1600 Bedienungshandbuch Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hochdruckreiniger Craftsman CM1600