Craftsman 315.172300 Bedienungshandbuch

Owner's ManualICRRFTSMRN'ITWO SPEED SABRE SAWDouble InsulatedModel No.315.172300Save this manual forfuture reference"_ CAUTION: Read an

ANGLE CUTTING (Bevel Cutting)See Figure 8.Bevel cutting angles may be adjusted from 0° to 45 °right or left. Angles for cuts from 0° to 45° in 15°incr

SPLINTER-FREECUTTINGSee Figure 10.The base of your saw has a narrow slot to permitsplinter-free cutting. It is especially useful whencutting plywood.

TO INSTALL OPTIONAL FLUSH CUTTINGBLADESSee Figure 11.Flush cutting blades should be used when makingclose or flush cuts to the walls.• Unplug your saw

GENERALAll parts represent an important part of the doubleinsulation system and should be serviced only by aqualified Sears service technician.Avoid u

Thefollowingrecommendedaccessoriesarecurrentlyavailableat Searsretailstores.• Bi-MetalBlades • MetalCuttingBlades• BladeAssortmentSets • WoodCuttingBl

NOTES:15

CRAFTSMAN SABRE SAW - MODEL NUMBER 315.172300SEE NOTE "A °' PAGE 171910816

[CRAFTSMAN SABRE SAW - MODEL NUMBER 315.172300The model number will be found on a plate attached to the motor housing. Always mention the modelnumber

at yourFor repair of major brand appliances in your own home...no matter who made it, no matter who sold it!1-800-4-MY-HOME sMAnytime, day or night(1-

TABLE OF CONTENTS• Table Of Contents ...

ToolUseandCare• Useclampsor anotherpracticalwayto secureandsupporttheworkpieceto a stable plat-form. Holding the work by hand or against yourbody is u

Hold tool by insulated gripping surfaces when performing an operation where the cutting tool maycontact hidden wiring or its cord. Contact with a &quo

SYMBOLSSYMBOL NAME DESIGNATION/EXPLANATIONV Volts VoltageA Amperes CurrentHz Hertz Frequency (cycles per second)W Watt Powermin Minutes Time•%, Altern

KNOW YOUR SAWSee Figure 1.Before attempting to use your saw, familiarize yourselfwith all operating features and safety requirements.Your saw has many

Your saw has been shipped completely assembledexcept for the blade. Inspect it carefully to make sureno breakage or damage has occurred during shippin

_. WARNING: Before connecting your saw tothe power supply source, always check to besure it is not in lock-on position (depress andrelease switch trig

GENERAL CU'n'INGSee Figure 6.Rest the front of the saw base on the workpiece andalign cutting edge of the blade with the line on yourworkpie