Craftsman 149.236321 Bedienungsanleitung

sEßmownersmanualMODEL NO. 149.236321SERIAL OR CODE NUMBER:Model and code number may be found on the back of the base.You should record both mode!

BASIC JOINTER—PLANER OPERATIONFor your safety do not exceed a 1/16" deep cut on a planing operation for work pieces wider than 1-1/2". For w

AWARNING: NEVER PLACE THE HEEL OF YOUR HAND AT THE END OF THE WORK PIECE WHEN FINISHING A CUT. THIS COULD RESULT IN YOUR HAND COMING

For beveling and chamfering operations, follow the same procedure as for jointing and planing described on pages 10 and 11, Before performing t

BLADE REPLACEMENT AND ADJUSTMENTNOTE: To rotate the cutterhead or to hold it steady, use a screwdriver in the slot in the cutter shaft thro

CRAFTSMAN 5-1/8 INCH JOINTER-PLANER MODEL No. 149.236321J3m

CRAFTSMAN 5-1/8 INCH JOINTi_.<-PLANER MODEL No. 149.236321PARTS LISTCAREF.NO.PART NO. DESCRIPTION QTY.14550-001-70 Base12 4550-011-70Infeed Table13

TROUBLE SHOOTING CHARTTROUBLEPROBABLE CAUSE REMEDYWood strikes outfeed table after passing over cutterhead1. Blades improperly adjusted below surface

FULL ONE-YEAR WARRANTY ON CRAFTSMAN. JOINTER — PLANERif within one year from the date of purchase, this Craftsman Jointer — Planer fails

7. KEEP CHILDREN AWAYAll visitors should be kept a safe distance from work area.8. MAKE WORKSHOP KID PROOFwith padlocks, master switches, or by removi

UNPACKING AND CHECKING CONTENTSModel 149,236321 Jointer-Planer Is shipped complete in one carton.Separate all parts from packing materials and

A SAFETY RULES FOR JOINTER—PLANER ASafety is a combination of operator common sense and alertness at all times when the Jointer—Planer

FENCELOCK KNOB1. From among the loose parts find the following:(1) Fence(2) Fence Brackets (2) Fence Segments (2) Tilt Indicators (2) Lock Knobs(4) 1

A= 11/16 Thick X 2'Wide X 10" LongThe 11/16 thickness can be obtained by pianing the board on the Jointer-planer.B= 1/2" to 3/4" T

INSTALLING THE JOINTER—PLANERIf the Jointer-Planer is to be used in a permanent location, it should be fastened securely to a firm supporti

то CHECK DEPTH OF CUTa. Place a straight edge on the outfeed table extending over the infeed table.b. Measure from the surface of the infeed table t