Craftsman 536.882091 Betriebsanleitung

120 V.A.C. 12 AMP. 60 Hz.Double Insulated20" Clearing WidthELECTRIC SNOW THROWERMODEL NO.536.882091Caution:Read and follow all SafetyRules and Op

MotorDnveAu sr/ _ Pu_ey• Release idler pulley.• Make sure the belt is seated properly.• Check the drive belt adjustment (see toAdjust the Drive Belt p

TROUBLEMotorrunserraticallyExcessivevibrationUnit fails topropel ItselfUnit falls todischargesnowMotor StopsCAUSEDamagedmotorObstruction in auger_osep

Table of Contents 2 Service and Adjustments 9-10Warranty 2 Storage 10Safety Rules 2-4 Troubleshooting 11Contents of Shipping Carton 4 Repair Parts 12-

• Check shear bolts and other bolts frequentlyfor proper tightness to be sure the snowthrower is in safe working condition.• Let engine and snow throw

• Never attempt to make any adjustments whilethe engine (motor) is running (except whenspecifically recommended by the manufac-turer).• Maintain or re

• Remove cotter pin, flatwasher and wavewasher from the worm end of chutecontrol rod and set aside (see figurebelow).• Insert the worm end of the chut

Chute Control Rod - Changes the direc-tion of snow discharge.Chute Deflector- Changes the distancethe snow is thrown.Discharge Chute - Changes the dir

• Snap strain relief clip down over loop ofcord, see figure below. Connect exten-sion cord to power plug on control switch.StrainReliefClip• To operat

packedsnowiscausingtheauger to slowdown and the chute to clog, back off andbegin a series of short jabs into the snow.These short back and forth, 4 to

TO ADJUST THE CHUTE CRANKASSEMBLYIfyou cannot rotate the chute crank fully tothe left and to the right, you need to adjustthe chute crank (see figure