Craftsman 247.77466 Betreibershandbuch PDF herunterladen (Seite 9)

Nevnr:

Use when fluid is below 20 ° F or above 150 ° F.

Use a solid engine/pump coupling.

Operate through relief valve for more than

several seconds.

Attempt to adjust unloading or relief valve

settings without pressure gauges.

Operate with air in hydraulic system.

Use teflon tape on hydraufic fittings.

Attempt to cut wood across the grain.

Attempt to remove partially split wood from the

wedge with your hands. Fully retract wedge to

dislodge wood with Jogdislodger.

UsingTheLogSplitter

Place the log splitter on level, dry, and solid

ground.

Place the beam in either the horizontal or vertical

position and lock in place with the appropriate

locking rod.

Block the front and back of both wheels.

Place the log against the end plate and only split

wood in the direction of the grain.

When necessary to stabilize the log, place your

hand only on sides of log. NEVER place hand on

the end between the log and splitting wedge.

Only one adult should stabilize the k)g and

operate the control handle, so the operator has

fun control over stabilizing the log and movement

of the splitting wedge.

ControlHandlePositions

Move control handle FORWARD or DOWN to

split wood.

Release the control handle to stop the wedge

movement.

Move control handle BACK or UP to return the

wedge.

Log Oislodger

The log dislodger is designed to remove any

partially split wood from the wedge. This may

occur while splitting large diameter wood or

freshly cut wood.

WARNING: Never remove partially split wood

from the wedge with your hands. Fingers may

become trapped between split wood.

To remove partially split wood from wedge, move

control handle to REVERSE position until wedge

is fully retracted to allow split wood portion to

contact the log dislodger.

Once removed from wedge with log dislodger,

split wood from opposite end or in another

k)cation.

Vertical Position

Pull the horizontal beam lock out to release the

beam and pivot the beam to the vertical position.

To lock the beam in the vertical position, pull out

on the vertical beam lock and pivot it to secure

the beam. See Figure 8.

Stand in front of the log splitter to operate the

control handle and to stabilize the log.

Horizootnl Position

Pull the vertical beam lock out and pivot it down.

Pivot the beam to the horizontal position.

The beam win lock automaticaNy in horizontal

position. See Figure 8.

Stand behind the reservoir tank to operate the

control handle and to stabilize the Jog.

_/ertical

Beam Lock

Figure 8

TransportingThe Log Splitter

Lower the beam to its horizontal position. Make

certain the beam is locked securely with the

horizontal beam lock.

Remove the spring clip and clevis pin from jack

stand. Support the tongue and pivot the jack

stand up against the tongue. Secure with the

spring clip and clevis pin previously removed.

See Figure 8.

Attach coupler hitch to a class I or higher 2" ball

on the towing vehicle, making certain to latch

securely.

Connect the safety chains to the towing vehicle.

Do not tow faster than 45mph and check local,

state, and federal requirements before towing on

any public road.

NOTE: Use caution when backing up. It is

recommended to use a spotter outside tbe vehicle.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Kommentare zu diesen Handbüchern

Keine Kommentare

Craftsman 247.77466 Betreibershandbuch Seite 9

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Holzspalter Craftsman 247.77466