Craftsman CompuCarve 133.217540 Betreibershandbuch PDF herunterladen (Seite 21)

Sears, Roebuck and Co. CompuCarve™ System (Rev 1.18) 04/23/07

Measuring a Board

The Measure Board function allows the user to measure the width or

length of an existing board. Simply load a board in the typical way and

press the ‘7’ (Measure) key on the keypad or use the up/down arrows to

navigate from the main menu. The display will then ask for the direction

the user wishes to measure.

Configuration Menu Options

The configuration menu allows the user to set project and machine

settings as well as access important run-time and serial number data. To

access the Configurations Menu, select the “0” (Options) key at the

CarveWright Main Menu or use the up/down arrows to locate the menu

and press ENTER. Use the up/down arrows to navigate to the following

menu options:

1) Quality (Default, Draft, Normal, Best)

The Quality menu option lets the user change the carving quality of

the project on the fly. Selecting default will use the settings selected

in the Designer software.

2) Version

The Version menu option will display the version number of the

control system firmware.

3) Usage Odometer

The Usage Odometer menu option will display the usage of the

machine in hours and minutes.

4) Show Serial Number

Selecting the Show Serial Number menu option will display the

machine’s unique serial number.

5) Jog Touch (Off/On)

Setting this option to On configures the machine so that the user is

required to manually set the location of the bit tip for the surface find

operation. During the project setup, the machine will prompt the user

to jog the bit tip over the location on the workpiece that will serve as

the top surface for the project. This is particularly useful when there

are already features carved into the material that prohibit the

machine from automatically detecting the top surface of the material.

The default setting is Off which allows the machine to automatically

find the top surface of the material.

6) Calibrate offsets

The Calibrate Offsets function is a simple procedure to allow the user

to fine-tune the machine for improved accuracy.

7) Sensor Check

The Sensor Check menu options allow access to all of the machine’s

real-time senor readings.

8) Sleep After (off, 1, 5, 10, 15, 30, 45, 60 min)

The Sleep After option is used to set when the electronics go into a

low power sleep mode. This interval is measures from the last

keypad command.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 45 46

Kommentare zu diesen Handbüchern

Keine Kommentare

Craftsman CompuCarve 133.217540 Betreibershandbuch Seite 21

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Elektrowerkzeuge Craftsman CompuCarve 133.217540