Craftsman 536.886260 Bedienungsanleitung PDF herunterladen (Seite 13)

OPERATION

Klick Pin

Ol! Fill Cap/Dipstick

Single Wheel Drive

Unlocked

Position

Figure 13

NOTE: Make sure that the klick pin is

in the single wheel drive position of the

axle only and not through the locked

position.

BEFORE STARTING THE ENGINE

1. Before you service or start the en

gine, familiarize yourself with the

snow thrower. Be sure you under

stand the function and location of all

control^.

2. Check the tension of clutch cable

before starting the engine. See To

Adjust The Control Cable para

graph in the Service & Adjust

ments section of this manual.

3. Be sure that all fasteners are tight.

4. Make sure the height adjust skids

are properly adjusted. See To Ad

just Skid Height paragraph in the

Service & Adjustments section of

this manual.

5. Check tire pressure (14-17

pounds). Do not exceed maximum

amount of pressure.

CHECK THE OIL:

NOTE: The engine was shipped from

the factory filled with oil. Check the lev

el of the oil. Add oil as needed.

1. Make sure the unit is level.

NOTE: Do not check the level of the

oil while the engine runs.

2. Remove the oil fill cap/dipstick.

Check the oil.

3. If necessary, add oil until the oil

reaches the FULL mark on the oil fill

cap/dipstick (see Figure 14). Do not

add too much oil.

F-001088J 13

NOTE: Oil level

must be between

full and Add mark

Figure 14

4. Tighten the fill cap/dipstick securely

each time you check the oil level.

NOTE: For extreme cold operating

conditions of 0°F and below, use a par

tial synthetic 0W30 motor oil for easier

starting.

NOTE: S.A.E. 5W30 motor oil may be

used to make starting easier in areas

where temperature is consistently 20°F.

or lower.

FILL GAS:

NOTICE; ENGINES WHICH ARE

CERTIFIED TO COMPLY WITH CAL

IFORNIA AND US EPA EMISSION

REGULATIONS FOR ULGE ENGINES:

Are certified to operate on regular un

leaded gasoline. Include the following

emission control system(s); EM, TWC

(if so equipped). Include any user ad

justable features-therefore no other ad

justments are needed.

A

WARNING: Experiences in

dicates that alcohol blended

fuels (called gasohol or

those using ethanol or methanol)

can attract moisture which leads to

separation and formation of acids

during storage. Acidic gas can dam

age the fuel system of an engine

while in storage.

NOTE: To avoid engine problems, the

fuel system must be emptied before

storage for 30 days or longer. Start the

engine and let it run until the fuel lines

and carburetor are empty. Use the car

buretor bowl drain to empty residual

gasoline from the float chamber. Use

fresh fuel next season. See the Stor

age section in this manual for additional

information.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 53 54

Kommentare zu diesen Handbüchern

Keine Kommentare