Craftsman 536.886260 Bedienungsanleitung PDF herunterladen (Seite 14)

OPERATION

Never use engine or carburetor cleaner

products in the fuel tank or permanent

damage may occur.

1. Fill the fuel tank only with a fresh,

clean, unleaded regular, unleaded

premium, or reformulated automo

tive gasoline. DO NOT use leaded

gasoline. Make sure that the con

tainer you pour the gasoline from is

clean and free from rust or other for

eign particles. Never use gasoline

that may be staie from long periods

of storage in the container.

A

WARNING: Gasoline is flam

mable. Always use caution

when handling or storing

gasoline.

Do not fill fuel tank while snow

thrower is running, when it is hot, or

when,^now thrower is in an en

closed area.

Keep away from open flame or an

electrical spark and do not smoke

while filling the fuel tank.

Never fill the tank completely. Fill

the tank to within 1/4”-1/2” from the

top to provide space for expansion

of fuel.

Always fill fuel tank outdoors and

use a funnel or spout to prevent

spilling.

Make sure to wipe up any spilled

fuel before stating the engine.

Store gasoline in a clean, approved

container and keep the cap in place

on the container.

TO STOP ENGINE

To stop engine, move the throttle con

trol lever to “STOP" position and re

move key. Keep the key in a safe

place. The engine will not start without

the key.

TO START ENGINE

(electric starter, if equipped)

Be sure that the engine has sufficient

oil. The snow thrower engine is

equipped with a 120 volt A.C. electric

starter and recoil starter. Before start-

F-001088J

14

ing the engine, be certain that you have

read the following information.

A

WARNING: The starter is

equipped with a three-wire

power cord and plug and is

designed to operate on 120 volt AC

household current.lt must be proper

ly grounded at all times to avoid the

possibility of electrical shock which

may be injurious to operator. Follow

all instructions carefully as set forth

in the “To Start Engine” section. De

termine that your house wiring is a

three-wire grounded system. Ask a

licensed electrician if you are not

sure. If your house wire system is

not a three-wire system, do not use

this electric starter under any condi

tions. If your system is grounded

and a three-hole receptacle is not

available at the point your starter will

normally be used, one should be

installed by a licensed electrician,

when connecting 120 volt AC “Power

Cord”, always connect the cord to

the Switch Box” on the engine first,

then plug the other end into the

three-hole grounded receptacle.

When disconnecting “Power cord”,

always unplug the end in the three-

hole grounded receptacle first.

COLD START

1. Be sure auger drive and traction

drive levers are in the disengaged

(RELEASED) position.

2. Move throttle control to”FAST’ posi

tion.

3. Remove the keys form the plastic

bag. Insert one key into ignition

slot. Make sure it snaps into place.

Do not turn key. Keep the second

key in a safe place.

4. Rotate choke knob clockwise to the

choke ON position.

5. Connect the power cord to the

switch box on the engine.

6. Plug other end of power cord into a

three-hole, grounded 120 VOLT, AC

receptacle. (See WARNING in this

section).

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 53 54

Kommentare zu diesen Handbüchern

Keine Kommentare