Craftsman 208cc Bedienungshandbuch PDF herunterladen (Seite 18)

SERVICE AND MAINTENANCE

WARNING

Before performing any type of maintenance/service, disengage all controls

and stop the engine. Wait until all moving parts have come to a complete

stop. Disconnect spark plug wire and ground it against the engine to

prevent unintended starting.

Follow the maintenance schedule given below. This chart describes service

guidelines only. Use the Service Log column to keep track of completed

maintenance tasks. To locate the nearest Sears Service Center or to schedule service,

call the following toll free number:1-888-331-4569.

MAINTENANCE SCHEDULE

Interval Item Service Service Log

Each Use and every 5 hours 1. Engine oil level

2. Loose or missing hardware

3. Unit and engine.

1. Check

2. Tighten or replace

3. Clean

1st 5 hours 1. Engine oil 1. Change

Annually or 25 hours 1. Spark plug

2. Control linkages and pivots

3. Wheels

4. Gear shaft and Auger shaft

5. 4-Way Chute Control™

1. Check

2. Lube with light oil

3. Lube with multipurpose auto grease

4. Lube with light oil

5. Check for cable slackness

Annually or 50 hours 1. Engine oil 1. Change

Annually or 100 hours 1. Spark plug 1. Change

Before Storage 1. Fuel system 1. Run engine until it stops from lack of fuel

Engine Maintenance

Checking Engine Oil

WARNING

Before lubricating, repairing, or inspecting, disengage all controls and stop

engine. Wait until all moving parts have come to a complete stop.

NOTE: Check the oil level before each use to be sure correct oil level is maintained.

When adding oil to the engine, refer to viscosity chart below. Engine oil capacity

is 600 ml (approx. 20 oz.). Do not over-fill. Use a 4-stroke, or an equivalent high

detergent, premium quality motor oil certified to meet or exceed U.S. automobile

manufacturer’s requirements for service classification SG, SF. Motor oils classified

SG, SF will show this designation on the container.

1. Remove the oil filler cap/dipstick and wipe the dipstick clean.

2. Insert the cap/dipstick into the oil filler neck, but do NOT screw it in.

3. Remove the oil filler cap/dipstick. If level is low, slowly add oil until oil level

registers between high (H) and low (L). See Figure 17.

4. Replace and tighten cap/dipstick firmly before starting engine.

Changing Engine Oil

NOTE: Change the engine oil after the first 5 hours of operation and once a season

or every 50 hours thereafter.

1. Drain fuel from tank by running engine until the fuel tank is empty. Be sure

fuel fill cap is secure.

2. Place suitable oil collection container under oil drain plug.

3. Remove oil drain plug and washer. See Figure 18 on next page.

Do not

fill above

High (H)

mark

Figure 17

4. Tip unit to drain oil into the container. Used oil must be disposed of at a

proper collection center.

CAUTION

Used oil is a hazardous waste product. Dispose of used oil properly. Do not

discard with household waste. Check with your local authorities or Sears

Service Center for safe disposal/recycling facilities.

5. Reinstall the drain plug and washer and tighten it securely.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare

Craftsman 208cc Bedienungshandbuch Seite 18

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Schneewerfer Craftsman 208cc