Craftsman 208cc Bedienungshandbuch PDF herunterladen (Seite 23)

SERVICE AND MAINTENANCE

6. Remove the frame cover from the underside of the snow thrower by

removing four self-tapping screws which secure it. See Figure 30.

7. Loosen and remove the shoulder screw which acts as a belt keeper. Refer to

Figure 31.

8. Remove the belt from around the auger pulley, and slip the belt between the

support bracket and the auger pulley. See Figure 32.

NOTE: Engaging the auger control will ease removal and reinstallation of the

belt.

9. Reassemble auger belt by following instructions in reverse order.

NOTE: Do NOT forget to reinstall the shoulder screw and reconnect the spring

to the frame after installing a replacement auger belt.

10. Perform the Auger Control test outlined in the Assembly section of this

manual.

Drive Belt

NOTE: Several components must be removed and special tools are required in order

to replace the snow thrower’s drive belt. Contact the nearest Sears Parts & Repair

Center to have the drive belt replaced.

Friction Wheel Inspection

If the snow thrower fails to drive with the drive control engaged, and performing

the Drive Control Cable Adjustment fails to correct the problem, the friction wheel

may need to be replaced. Examine the friction wheel rubber for signs of wear or

cracking and replace wheel if necessary.

NOTE: Several components must be removed and special tools are required in order

to replace this snow thrower’s friction wheel. If your friction wheel needs to be

replaced, contact the nearest Sears Parts & Repair Center.

To inspect the friction wheel, proceed as follows:

1. Allow the engine to run until it is out of fuel. Do not attempt to pour fuel

from the engine.

2. Carefully pivot the snow thrower up and forward so that it rests on the auger

housing.

3. Remove the frame cover from the underside of the snow thrower by

removing four self-tapping screws which secure it. Refer to Figure 30.

4. Examine the friction wheel for signs of wear or cracking.

Figure 30

Figure 31

Figure 32

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 59 60

Keine Kommentare

Craftsman 208cc Bedienungshandbuch Seite 23