Craftsman 113 Bedienungshandbuch PDF herunterladen (Seite 12)

13, Raise blade all the way up,

14. Carefully move fence against blade.

15. Move front bar until "'0"" mark on rip scale is

approximately inline with indicator.

16. Move FRONT bar upwards until fence is approximately

1/32 in. above table ... tighten screw at left end of

bar.

NOTE: Fold a piece of newspaper making 8 thicknesses

and place between rip fence and table to act as a spacer.

This will hold the fence off of the table approx. 1/32

in.

17. Adjust rear bar so that the fence is approximately 1/32

in. above table make sure it is square with fence guide

bar rod ... tighten screw at end of bar.

18. Replace screws in rear of table extension . .. be sure

top surface of extension is PARALLEL to top surface

of rear guide bar.

8 THICKNESSES

OF PAPER

19. Move fence to RIGHT edge of table ... make sure it is

approx. 1/32 in. above table at front and rear and

tighten screws,

8 THICKNESSES

OF PAPER

ALIGNING RIP FENCE

The fence should slide easily along the bars and always

remain in alignment (parallel to sawblade and miter gauge

grooves),

The alignment is maintained by a spring underneath the

fence which bears against the front guide bar.

To move the fence, loosen the lock handle and grasp the

fence with one hand at the front.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

Keine Kommentare

Craftsman 113 Bedienungshandbuch Seite 12