Craftsman 113 Bedienungshandbuch PDF herunterladen (Seite 29)

PLOUGHING AND MOLDING

PLOUGHING is grooving with the grain the long way of the

workpiece, using the fence. USE proper holddowns and

feed devices.

MOLDING is shaping the workpiece with the grain the long

way of the workpiece, using the fence. Use proper

holddowns and feed devices,

RESAWING

RESAWlNG is known as ripping a piece of wood through

its thickness. Do not attempt to resaw BOWED or

WARPED material. NOTE: To RESAW a piece of wood

wider than 3-3/8 in .... it will be necessary to remove the

blade guard ... and use the AUXILIARY FENCE/WORK

SUPPORT. (See "Work Helpers").

Clamp it to the table so that the workpiece will SLIDE

EASILY but not TILT or MOVE SIDEWAYS without

BINDING between the two fences.

Do not clamp directly to the bottom edge of the table

because the "swivel" of the clamp will not grip properly.

Place a small block of wood between the bottom edge of

the table and the "C" clamp.

WARNING: FOR YOUR OWN SAFETY ...

1. DO NOT "BACK UP" (REVERSE FEEDING) WHILE

RESAWlNG BECAUSE THIS COULD CAUSE A

KICKBACK.

SMALL BLOCK

OF WOOD

2. MAKE FIRST PASS TO A DEPTH SLIGHTLY LESS

THAN ONE-HALF THE WIDTH OF THE BOARD;

KEEP SAME FACE OF BOARD AGAINST FENCE

FOR SECOND PASS AS THE FIRST PASS.

3. INSTALL BLADE GUARD IMMEDIATELY UPON

COMPLETION OF THE RESAWlNG OPERATION.

CUTTING PANELS

When cutting panels (whenever fence is positioned odtside

of table surface); ALWAYS use the AUXILIARY

FENCE/WORK SUPPORT.

1. Unlock fence and raise rear end.

2. Position AUXILIARY FENCE/WORK SUPPORT as

shown and attach it with two "C" clamps.

AUXILIARY FENCE/

WORK SUPPORT

RABBETING

Rabbeting is known as cutting out a section of the corner

of a piece of material, across an end or along an edge.

To make a RABBET requires cuts which do not go all the

way through the materiaL. Therefore the blade guard must

be removed.

1: Remove blade guard.

2. For rabbetilag along an edge (long way of workpiece) as

shown, add facing to rip fence (see 5. RIP FENCE, p.

21) approximately as high as the workpiece is wide.

Adjust rip fence and blade to required dimensions; then

make first cut with board flat on table as any rip (type)

cut; make second cut with workpiece on edge. Follow

all precautions, safety instructions, and operational

instructions as for ripping, or rip type operations,

including feather boards and push stick, etc.

3. For rabbeting across an end, for workpiece 101/2" and

narrower make the rabbet cut with the board flat on

the table using the miter gage fitted with a facing (per

"6. MITER GAUGE" on p.21). DO NOT use the rip

fence.

4. INSTALL BLADE GUARD IMMEDIATELY UPON

COMPLETION OF RABBETING OPERATION.

Rabbet cuts can also be made using the dado head or

molding head.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare

Craftsman 113 Bedienungshandbuch Seite 29

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Bohrmaschinen Craftsman 113