Craftsman 113 Bedienungshandbuch PDF herunterladen (Seite 19)

8°

Press guard onto support so that bottom of guard is

approximately 3/4 in. away from beFt°

NOTE: To remove guard, lift up on LONG TABS of

clips ... pull guard outward. The clips should remain

on the BELT GUARD SUPPORT.

8/4 IN.

ASSEMBLING HOLD-DOWN

(Included with Model 113.298240)

Locate the clamp assembly, support rod, two wing screws

and two washers in loose parts bag.

Screw the support rod (I) tightly into the hole in the miter

gauge head.

Position the clamp assembly (2) on the handle and rod...

install washers (3) and wing screws (4).

NOTE: The small knob (5) on the clamp screw must not

turn. Check nut underneath it ... it must be tight against

the knob. Use a 1/2 inch wrench to tighten it.

CLAMP LOCK

LATCH

PLUGGING IN MOTOR

1. From among the loose parts, find two wire ties

2. Route motor cord along right side of cabinet and snap

ties in 1/4" hole in side of cabinet. Secure two cords in

wire ties.

3. Plug motor cord into outlet on side of switch box.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 47 48

Keine Kommentare

Craftsman 113 Bedienungshandbuch Seite 19