Craftsman 536.886260 Bedienungsanleitung PDF herunterladen (Seite 15)

OPERATION

7. Push the primer button while cov

ering the vent hole as follows; Re

move finger from primer button

between primes.

Do not prime if temperature above

50° F(10“ C),

Push two time if temperature is 50°

F(10° C) to15°F(-10° C).

Push four times if temperature is

below 15° F(-10° C).

8. Push down on the starter button

until the engine starts. Do not crank

for more than 10 seconds at a time.

This electric starter is thermally pro

tected. If overheated it will stop au

tomatically and can be restarted

only when it has cooled to a safe

temperature (a wait of about 5 to 10

minutes is required).

9. When tfie engine starts, release the

starter button and move choke le

ver to ”1/2 choke” position. When

engine runs smoothly, move choke

lever to ”No Choke” Position.

10. Disconnect power cord from recep

tacle, first, and then from switch

box.

NOTE: Allow the engine to warm up for

several minutes before blowing snow in

temperatures below 0°F.

11. Run engine at full throttle “FAST’

when throwing snow.

WARM START

if restarting a warm engine after a short

shutdown, leave choke at “OFF and do

not push the primer button. If the en

gine fails to start, follow the Cold Start

instructions.

TO START ENGINE

(recoil starter)

Be sure that the engine has sufficient

oil. The snow thrower engine is

equipped with a recoil starter. Before

starting the engine, be certain that you

have read the following information,

F-001088J

COLD START

1. Be sure auger drive and traction

drive levers are in the disengaged

(RELEASED) position.

2. Move throttle control to”FAST’ posi

tion.

3. Remove the keys form the plastic

bag. Insert one key into ignition

slot. Make sure it snaps into place.

Do not turn key. Keep the second

key in a safe place.

4. Rotate choke knob clockwise to the

choke ON position,

5. Push the primer button while cov

ering the vent hole as follows: Re

move finger from primer button

between primes.

Do not prime if temperature above

50° F(10° C).

Push two time if temperature is 50°

F(10° C)to15°F(-10° C).

Push four times if temperature is

below 15° F (-10° C).

6. Pull the starter handle rapidly. Do

not allow the handle to snap back,

but allow it to rewind slowly while

keeping a firm hold on the starter

handle.

7. As the engine warms up, move

choke lever to ”1/2 choke” position.

When engine runs smoothly, move

choke lever to ”No Choke” Posi

tion.

NOTE: Allow the engine to warm up for

several minutes before blowing snow in

temperatures below 0°F.

8. Run engine at full throttle “FAST

when throwing snow.

WARM START

If restarting a warm engine after a short

shutdown, leave choke at “OFF” and do

not push the primer button. If the en

gine fails to start, follow the Cold Start

instructions.

FROZEN STARTER

If the starter is frozen and will not turn

engine:

1. Pull as much rope out of the starter

as possible.

15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 53 54

Kommentare zu diesen Handbüchern

Keine Kommentare