Craftsman 208cc Bedienungshandbuch PDF herunterladen (Seite 20)

SERVICE AND MAINTENANCE

Lubrication

Gear Shaft

The gear (hex) shaft should be lubricated at least once a season or after every 25

hours of operation.

1. To prevent spillage, remove all fuel from tank by running engine until it

stops.

2. Carefully pivot the snow thrower up and forward so that it rests on the auger

housing.

3. Remove the lower frame cover from the underside of the snow thrower by

removing the self-tapping screws which secure it.

4. Apply a light coating of anti-seize to the hex shaft. See Figure 21.

NOTE: When lubricating the hex shaft, be careful not to get any oil on the aluminum

drive plate or rubber friction wheel. Doing so will hinder the snow thrower’s drive

system. Wipe off any excess or spilled oil.

Wheels

At least once a season, remove both wheels. Clean and coat the axles with a

multipurpose automotive grease before reinstalling wheels.

Auger Shaft

At least once a season, remove the shear pins on auger shaft. Spray lubricant inside

shaft, and around the spacers and flange bearings found at either end of the shaft.

See Figure 22.

Shave Plate and Skid Shoes

The shave plate and skid shoes on the bottom of the snow thrower are subject to

wear. They should be checked periodically and replaced when necessary.

NOTE: The skid shoes on this machine have two wear edges. When one side wears

out, they can be rotated 180° to use the other edge.

To remove skid shoes:

1. Remove the two carriage bolts, washers, and hex flange nuts that secure

each skid shoe to the snow thrower.

2. Reassemble new skid shoes with the four carriage bolts (two on each side),

washers, and hex flange nuts. Refer to Figure 23.

To remove shave plate:

1. Remove the carriage bolts and hex nuts which attach it to the snow thrower

housing.

2. Reassemble new shave plate, making sure heads of carriage bolts are to the

inside of housing. Tighten securely. See Figure 23.

Figure 21

Figure 22

NOTE: Augers not shown for clarity.

Figure 23

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 59 60

Keine Kommentare

Craftsman 208cc Bedienungshandbuch Seite 20